Name: Ponto
SKU: 1193
Price: 9999.00 USD
Availability: InStock

Size

Item	Size
Length(outer)	250cm
Length(inner)	132cm
Width(outer)	90.5cm
Width(inner)	34.5cm

Item	Size
Water line(length)	238cm
Water line(Width)	78cm
Tube	28cm

Weight

Item	Weight	Strength
Packraft body	2950g	210D
Seat	263g	210D
Backrest	228g	Rod Support Backrest 2(RSB2)
Inflation bag	135g	30D CORDURA®
Tie strap	25g	/
Floor(black)	/	420D
Total weight	3520g	/
Advised paddler’s weight	102kg	/
Advised capacity	138kg	/

Notes

Measurement data may vary according to temperature and material difference, which is a normal phenomenon.

Internal Storage Bag (ISS Models)

Instructions for Use

1.Put equal weight within each storage bag on either side. As the bags cannot be accessed until deflation, only store items which do not require on-the-water access.

2.Put the luggage into the storage bag, fold the top of the bag, tighten the storage bag as much as possible, and then insert the buckle at the top opening.

3.Open the Tizip and put the storage bag inside the packraft tubes.

4.Unfasten the buckle at the top of the bag after the storage bags are inserted into the tubes, pass the buckles through the two tie downs and re-fasten the buckle.

Tie down fixings within the tubes can be used to fix the storage bags in place. This ensures that even as the packraft moves, the storage bags will not slide back and forth.

Connector Overview

Backrest Connector

RSB2

Inflatable Backrest

Adjustable footrest Connector

Adjustable footrest

Water-filled footrest

Function:
Water stored inside the footrest adds weight to the lower bow, minimizing yaw and pitching during paddling. With less drag than a bow-mounted skeg, it delivers smoother and more efficient forward motion.

Water-filling Procedure:

1.Submerge the footrest in the water to scoop water inside.If the water level is low, use the paddle to assist.

2.Use the markings inside the footrest to estimate the desired water volume.

3.Fold and seal the end of the footrest.

4.Lay the footrest flat with the base of the hose at a relatively higher point.
Open the hose valve to release air. When the water level in the transparent hose exceeds approximately one-third of the hose height, close the valve.

5.Fold the end portion again and secure it tightly.

6.Place the footrest at the very front of the hull, pressing it firmly in place to serve as both ballast and a foot support.

Important Notes:

The tail end of the water-filled footrest must be folded at least four times to ensure a proper seal.

Air should be released through the upper hose as completely as possible. If air is not removed, the water inside the footrest may slosh, which can significantly reduce stability.

Excess air inside the footrest may also increase the risk of ballast water leakage.

Accessories

Seat
263g

Rod Support Backrest 2(RSB2)
228g

Inflatable Backrest
120g

Water-filled footrest
241.6g

Skeg set S
86g

Inflation bag
135g

Use pictures

Videos Recommended

Reprint（Address：https://www.youtube.com/watch?v=wwLSqEU1ixI Author：JOKKMOKKGUIDERNA）

Reprint（Address：https://www.youtube.com/watch?v=K08oSPqMqdI Author：キャンピークcAmp peak）

All videos related to our products are sourced from the Internet, which are shot and owned by the author. We just recommend you to watch them, feel free to contact us if any problems with it.