Size
| Item | Standard | XL |
|---|---|---|
| Length (outer) | 294cm | 319cm |
| Length (inner) | 173.5cm | 187cm |
| Width (outer) | 87.5cm | 94cm |
| Width (inner) | 34.5cm | 36cm |
| Item | Standard | XL |
|---|---|---|
| Water line (length) | 275cm | 297cm |
| Water line (width) | 80cm | 88cm |
| Tube | 26.5cm | 29cm |
Weight
| Item | Standard | XL | Strength |
|---|---|---|---|
| Packraft (hull+Deck) | 3800g | 4450g | 210D |
| Seat | 226g | 210D | |
| Backrest | 348.5g | Rod Support Backrest 2 (RSB2) | |
| SpraySkirt | 650g | / | |
| Water-filled footrest | 241.6g | / | |
| Inflation bag | 135g | 30D CORDURA® | |
| Tie strap | 25g | / | |
| Floor (black) | / | 840D | |
| Total weight | 4730g | 5380g | / |
| Advised paddler’s weight | 85kg | 95kg | / |
| Advised capacity | 118kg | 130kg | / |
| Recommended Air Pressure | 1.5~2psi |
Notes: Measurement data may vary according to temperature and material difference, which is a normal phenomenon.
- 185cm and above: XL
- Below 180cm: Standard
- 180–185cm: Please consider your height and weight together with the product dimensions, and choose accordingly.



In warm conditions, the rear deck can be removed. Attach the clips of the securing straps to both sides of the PFD, then fasten the front deck spray skirt to the hook-and-loop (Velcro) surfaces on the straps. This configuration provides improved ventilation to reduce heat buildup while still preventing most splashing water from entering the cockpit.
This new connection system has been tested and allows the spray skirt to be released quickly using the pull handle in the event of an accidental capsize.
Recommended Air Pressure
Air pressure changes with temperature. In cold water, inflate to the higher limit to compensate for air contraction. In strong direct sunlight, store the raft in the shade; if shade is unavailable, release some air.
psi
Internal Storage Bag (ISS Models)
Instructions for Use
1.Put equal weight within each storage bag on either side. As the bags cannot be accessed until deflation, only store items which do not require on-the-water access.
2.Put the luggage into the storage bag, fold the top of the bag, tighten the storage bag as much as possible, and then insert the buckle at the top opening.
3.Open the Tizip and put the storage bag inside the packraft tubes.
4.Unfasten the buckle at the top of the bag after the storage bags are inserted into the tubes, pass the buckles through the two tie downs and re-fasten the buckle.
Tie down fixings within the tubes can be used to fix the storage bags in place. This ensures that even as the packraft moves, the storage bags will not slide back and forth.
Water-filled footrest



Function:
Water stored inside the footrest adds weight to the lower bow, minimizing yaw and pitching during paddling. With less drag than a bow-mounted skeg, it delivers smoother and more efficient forward motion.
Water-filling Procedure:
1.Submerge the footrest in the water to scoop water inside.If the water level is low, use the paddle to assist.
2.Use the markings inside the footrest to estimate the desired water volume.
3.Fold and seal the end of the footrest.
4.Lay the footrest flat with the base of the hose at a relatively higher point.
Open the hose valve to release air. When the water level in the transparent hose exceeds approximately one-third of the hose height, close the valve.
5.Fold the end portion again and secure it tightly.
6.Place the footrest at the very front of the hull, pressing it firmly in place to serve as both ballast and a foot support.
Important Notes:
The tail end of the water-filled footrest must be folded at least four times to ensure a proper seal.
Air should be released through the upper hose as completely as possible. If air is not removed, the water inside the footrest may slosh, which can significantly reduce stability.
Excess air inside the footrest may also increase the risk of ballast water leakage.
Accessories
348.5g
228g
241.6g
650g
115.8g
135g









Hippo Packraft Backpack